| Additional Information | Shape: Circles Care and Application:
Instructions:
- Clean and dry surface before application.
- Peel tape from fastener and press firmly into place.
- Adhesive reaches maximum strength after 24 hours.
Note: Not recommended for fabrics, flexible vinyl or outdoor use. Continued exposure to full sunlight can damage fastener. Removal Instructions: - Warm the tape (Hook or Loop) with a hair dryer. (Do not use a heat gun)
- Peel off the tape (Hook or Loop) the adhesive will remain on the substrate
- Warm the adhesive with the hair dryer (again, do not use a heat gun), peel off a piece and roll in a ball
- Cool the adhesive down. This may be done with ice in a plastic bag (only takes a few moments)
- Stick the ball on the adhesive which is on your substrate and pull it off
- Repeat step # 5 until the adhesive is completely removed from the substrate. This may take some time
- If any residue tackiness remains on the substrate you may now use a commercial remover like Goo Gone, acetone, WD-40, mineral spirits or citrus based cleaners
Weight Rating: 1 lbs per square inch up to 5 lbs Functional Temperature Range: 0-100° F (-18-38° C) |
